inda A0452A Bedienungsanleitung Seite 4

• Turn the unit off when you put it down.
• Handle the hairdryer making sure to never obstruct the air inlet and
outlet grilles. Lack of air suction will overheat the appliance, temporarily
disabling it.
• Do not use hair-spray while the appliance is switched on.
Installation:
The wall holder may be installed in one of two ways:
A = for fixed connection lead
B = for mobile connection lead
Attention: before installing the wall holder always switch off
the general switch of your mains electricity.
Each time the appliance is opened, the switch must be used to disconnect
the appliance. The cable to connect to the power supply must be type
H05VV-F 2x1,5 mm
Method A
1 Unscrew the screw G and remove the cover from the wall unit. (fig.1)
2 Mark the fastening holes on the wall. Drill the wall with drill Ø 6. (fig.2)
3A Break the plastic membrane D so that the power supply conductor can
pass through. (fig.3a)
Unscrew the screws of the cable clamp F (fig. 3a).
Insert the power supply cable, connect it to the E terminal and tighten the
screws of the cable clamp F (fig. 3b).
CAUTION: this device has double insulation but does not have an earth.
Insert the dowels and fasten the rear part of the wall support to the wall
with the screws provided. (fig.3a)
4 Apply the wall-support cover and fasten it with screw G. (fig.4).
5 Switch the power on at the mains switch. The hair dryer is now ready
to use.
Method B
1 Unscrew the screw G and remove the cover from the wall unit. (fig.1)
2 Mark the fastening holes on the wall. Drill the wall with drill Ø 6. (fig.2)
All manuals and user guides at all-guides.com
2 .
4