en
Technical specifications
Problem
Display shows
"Empty drip trays"
despite them being empty�
Display shows
"Insert drip trays" even
though drip tray in use�
Water dripped onto the
inner floor of the appli-
ance when the drip tray
was removed�
Display shows
"Switch off with power
switch and then back on
after 30 sec!"
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
Technical specifications
Power connection (voltage – frequency)
Heater wattage
Maximum static pump pressure
Maximum water tank capacity (without filter)
Maximum capacity of the coffee bean container
Length of power cable
Dimensions (H x B x D)
Weight, empty
Type of grinding unit
56
Cause
Drip tray is soiled and wet�
Emptying is not detected
when the appliance is
switched off�
Inside of appliance
(tray holder) dirty�
The coffee grounds con-
tainer is not fully inserted�
Drip tray was removed too
soon�
Appliance is too warm�
Dirty brewing unit�
Solution
Clean and dry the drip tray
thoroughly�
When the appliance is switched
on, remove and re-insert the drip
tray�
Clean the inside�
Push the coffee grounds
container all the way in�
Wait a few seconds after the
last drink was dispensed before
removing the drip tray�
Leave the appliance to cool
down�
Clean the brewing unit�
220-240 V – 50/60 Hz
1600 W
19 bar
2�4 l
500 g
1�7 m
455 x 495 x 375 mm
19-20 kg
Ceramic