Initial Use; Setting Up The Appliance - NEFF C1.KS61N0 Gebrauchsanleitung

E
Touch E to open the selection of service
programmes. Run the desired programme
as described in the section "Service
programmes"�
Double G
Touch G after selecting a drink to
prepare two cups simultaneously (see the
section "Two cups at once")�
My Coffee B
Touch B to open the selection of "Per-
sonalised beverage preparation"� Personal
settings for coffee drinks can be saved and
called up (see the section "Personalised
drinks")�
C
Touch C for either beverage preparation
or to launch a service programme�
If you touch C again while the drink is
being prepared, dispensing will be prema-
turely halted�
Arrow navigation button
Press the arrow on the arrow button to navi-
gate in the display or to change parameters�
Display
The display shows drinks, settings and
information (see the section "Display")�

Initial use

General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans� Do not use coffee beans
that have been glazed, caramelised or
treated with other additives containing
sugar, since they will block the brewing unit�
A
Before the appliance can be
switched on and used, it must
be assembled and connected
according to the enclosed assembly
instructions�

Setting up the appliance

■ Remove any protective plastic film.
F
Important: Only use the appliance
in a frost-free room� If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use�
■ Take hold of the appliance door by the
recessed grip and open�
■ Remove the water tank, rinse it and fill it
with fresh water up to the "max�" mark�
■ Replace the water tank and click into
place�
■ Remove the bean container, fill with
coffee beans and replace�
■ Set the mains switch to I and close
the appliance door�
The appliance heats up and is rinsed�
The display is activated�
"Please set your preferred language."
appears�
■ Press the M arrow button. The field
"Deutsch" has a light background� The
language can be changed�
■ With the L arrow button select the
desired language�
■ Press the N arrow button. The field
"Language" has a light background�
■ Select the "Water hardness" with the L
arrow button�
en
Initial use
35