Kenwood KA-50 Bedienungsanleitung Seite 12

CONTROLS, INDICATORS AND CONNECTORS
@ KENWOOD - stTEREO INTEGRATED AMPLIFIER nuun,
KA-30 >
@ KENWOOD STEREO INTEGRATED AMPLIFIER mum. K
@ POWER switch/POWER indicator
Push in to turn on power. The POWER indicator (LED) will
light. Push it again to turn power off.
@ PHONES jack
Stereo headphones are plugged into this jack.
@® SPEAKERS switch
A, B OFF — This position silences all speakers to permit
private use of headphones.
A ON — Activates speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON — Activates speakers connected to the SPEAKERS B
terminals on the rear panel.
A, B ON — Activates speakers connected to the SPEAKERS
A and B terminals simultaneously.
© TONE controls
BASS — Turn clockwise to increase bass response,
counterclockwise to lower bass response.
TREBLE — Turn clockwise to increase treble response,
counterclockwise to reduce treble response.
Flat response is obtained when the two tone controls are set
to their mid-range positions.
© BALANCE control
This control permits balancing of left and right channels when
an imbalance exists from the sound source, or to correct
acoustic imbalance due to room conditions. Turn it to the left
from the center position to boost the left channel: turn it to the
right of center to raise the level of the right channel.
@ PEAK POWER LEVEL indicator
The PEAK POWER LEVEL indicators (LEDs) show the effec-
tive power being delivered to your speakers.
The indicators are calibrated for an 8 ohms load. If 4 ohms
speakers are used, multiply the reading by 2; for 16 ohms
speakers, divide the reading by 2.
< KA-50
VOLUME CONTROL
VOLUME CONTROL
@ input selector indicators
With the POWER switch set to ON, four indicators are lit in
green when no input selector switch is used. When the
desired input selector switch is used the green light above the
switch is turned out to be yellow. The rest of the indicators re-
main in green.
@® TAPE A switch
OFF — The signal applied to the record terminals of a tape
deck is heard. This setting is indicated by the green light.
ON — To monitor a recording in progress or to play back a
tape from a tape deck connected to the TAPE A jacks.
This setting is indicated by the yellow light.
Note: ——_—_— $$$
Be sure to set TAPE A switch to "OFF" when not operating a tape deck.
© input selector switches |
PHONO — Push this button to select the turntable connected
to the PHONO input jacks on the rear panel. The built-in
yellow indicator will light.
TUNER — Push this button to select the tuner connected to
the TUNER input jacks on the rear panel. The built-in
yellow indicator will light.
TAPE B PLAY/AUX — Push this button to select source con-
nected to the TAPE B PLAY/AUX jacks on the rear panel.
The built-in yellow indicator will light.
@ LOUDNESS switch
ON — Bass notes are boosted at low listening levels. This
precisely offsets a characteristics of human hearing
whereby we are less sensitive to bass notes at very low
listening levels.
OFF — The low-level bass boost is removed and the
VOLUME control provides flat response at all settings.
@ VOLUME control
This control adjusts left- and right-channel volume simultane-
ously. Set it for the desired listening level.
KA-50-KA.30
a
i
i
¢
4
t f
3
4 ;
'
4
|
i
4
|
4
4
!
4%
4
4
a
4
i
'a
i