Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SPEAKERS
10 mm
Remove insulation
aaa
aes
;
3/3"
from lead tip.
—_——
Twist wire tightly,
and solder.
&
or
Loosen the
Insert the
Tighten the
screw.
wire.
screw.
Speaker Lead Connection
TURNTABLE
lf the turntable has a ground wire, connect it to the unit's
GND terminal to avoid hum.
TUNER
Use the TUNER terminals for connection to an FM stereo
or AM-FM stereo tuner.
:
TAPE B PLAY/AUX jacks
INPUT TAPE B PLAY/AUX jacks are used to connect other
high-level signal sources, such as tuners, extra tape decks
(equipped with preamps), TV or VTR sound outputs,
mic
preamps, etc.
TAPE DECKS
Playback
Plug the left and right output cables of the tape deck into
the [L] and [R] TAPE A PLAY jacks.
Record
Plug the left and right input cables of the tape deck into the
and [R] TAPE A REC jacks.
Second Tape Deck
Plug the output cables from the second tape deck into the
TAPE B PLAY/AUX Jacks.
AC OUTLETS
The AC outlets on the rear panel of the unit may be used to
supply power to other components
in the system, such as
turntable, tape deck, etc. Never connect equipment whose
power consumption exceeds the maximum
value shown at
each outlet.
1. SWITCHED outlets: These outlets supply power only when
the unit is turned
on.
Maximum
total
capacity
(both
outlets) is 100 watts.
2. UNSWITCHED
outlet: This outlet provides power when
the unit is plugged into an active AC wall outlet, regardless
of the setting of the POWER switch. Its maximum capacity
is 200 watts.
seta
RAT
A R E S :
Wf
:
;
4 }
fa
q
|
fi
i
2
4
q
i
it
q
Werbung
