Siemens EQ.700 integral TQ7 Serie Gebrauchsanleitung Seite 22

en Home Connect
Overview of the Home Connect settings
You can find an overview of the Home Connect settings and network settings
here.
Basic setting
WiFi connection
Remote start
Add mobile
device
Network informa-
tion
Delete network
settings
Software update
12.4 Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the Home Con-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip: For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
visit the service/support section of
your local website: www.home-con-
nect.com.
12.5 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
22
Selection
On
Off
On
Off
-
-
-
-
Description
Switch off the wireless module during
long absences or to save energy.
Note: In networked standby mode
your appliance requires max. 2 W.
Switch remote start on the appliance
on and off.
Note: With the Home Connect app
only switch-off is possible.
Connect the appliance to the "Home
Connect" app or additional accounts.
Display network information and appli-
ance information.
Note: You cannot operate your appli-
ance via the "Home Connect" app
without a network connection.
Note: This setting is only available
with a software update.
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
Unique appliance identification
¡
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
Security certificate of the Wi-Fi
¡
communication module (to ensure
a secure data connection).
The current software and hardware
¡
version of your appliance.
Status of any previous reset to
¡
factory settings.
This initial registration prepares the
Home Connect functions for use and
is only required when you want to
use the Home Connect functions for
the first time.