Herunterladen Inhalt Inhalt Diese Seite drucken

Medi circaid juxtalite lower leg inelastic compression system Gebrauchsanweisung Seite 4

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 5
English
Step 5: The garment should lay
flat and wrinkle free against the
leg. Adjust each band to a firm
and comfortable compression
level. Ensure that the bands are
placed in an alternating order.
Step 6: Once all bands are
secured, inspect the garment for
any gaps or creases. Adjust the
bands as necessary.
Note:
Once the correct pressure is set
using the BPS card, you may fold
the top and bottom part of the
circaid undersleeve over the top
and bottom edge of the circaid
juxtalite garment.
Donning the circaid
compression anklet.
First fold the bottom part of the
circaid undersleeve over the
bottom edge of the lower leg
component (5i).
Slide the circaid compression
anklet onto the foot and ensure
that it is pulled high enough so
that it overlaps with the circaid
juxtalite garment. Ensure that
there are no wrinkles in the
anklet.
Doffing instructions
To remove the garment, remove
the circaid compression anklet
first. Then unfold the circaid
undersleeve. Detach all bands of
the legging starting with the top
band. Fold each band onto itself
to keep the Velcro tabs lint-free.
Remove the garment and then
remove the circaid undersleeve.
Using the Built-In-Pressure
card:
Step 1: Locate the Built-In-
Pressure card in your packaging.
Step 2: Identify your prescribed
pressure scale using the
color-coded system.
Step 3: Starting with the bottom
band, line up the vertical line on
the card with one of the BPS lines
on the bottom band.
Step 4: Note where the second
BPS line lines up with the card´s
compression ranges (6a).
Step 5: If the BPS line on the
garment either falls short (6b) or
goes beyond the correct
compression range (6c), readjust
the band as necessary so that the
second BPS line on the garment
is aligned with the prescribed
compression range (6a).
Completely loosen the band
before reapplying it if too much
tension has been applied.
Step 6: Repeat the steps 3 - 5 for
each band going up the leg. Be
sure to adjust all bands to the
same compression level. Bands
may need adjusting throughout
the day to maintain the
prescribed compression range.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis