Herunterladen Diese Seite drucken

DeWalt DXV25S Bedienungsanleitung Seite 6

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 32
EN
• Some wood contains preservatives which can be
toxic. Take extra care to prevent inhalation and
skin contact when working with these materials.
Request and follow any safety information available
from the material supplier.
• Do not use vacuum as a step ladder.
• Do not place heavy objects on vacuum.
• An extension cord must have adequate wire size
for safety.
• If an extension cord is to be used outdoors it must
be marked.
WARNING:
To reduce the exposure to these chemicals, wear
approved safety equipment such as dust masks
that are specially designed to filter out microscopic
particles.
ON MOTOR HOUSING :
WARNING:
• TO REDUCE THE RISK OF INJURY, USER
MUST READ INSTRUCTION MANUAL. DO NOT
LEAVE THE VACUUM UNATTENDED WHEN IT IS
SWITCHED ON. DO NOT PICK UP FLAMMABLE,
COMBUSTIBLE OR HOT MATERIALS. DO NOT
USE AROUND EXPLOSIVE DUST, LIQUIDS OR
VAPORS. ELECTRICAL DEVICES PRODUCE
ARCS OR SPARKS WHICH CAN CAUSE FIRE
OR EXPLOSION. DO NOT USE AT FILLING
STATIONS OR ANYWHERE GASOLINE IS STORED
OR DISPENSED. DO NOT VACUUM TOXIC OR
CARCINOGENIC MATERIALS OR OTHER HEALTH
ENDANGERING MATERIALS SUCH AS ASBESTOS
OR PESTICIDES. ALWAYS USE PROPER EYE AND
RESPIRATORY PROTECTION. TO REDUCE THE
RISK OF ELECTRICAL SHOCK, DO NOT EXPOSE TO
RAIN. STORE INDOORS. WHEN SERVICING, USE
ONLY IDENTICAL REPLACEMENT PARTS. NOT TO
BE USED AS A STEP STOOL.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
UNPACKING & SETUP SUMMARY
1. Pull lid latches in an outward motion, remove
power head and some accessories that may have
been shipped in the tank.
2. Attach heavy-duty rubberized casters following the
instructions in this manual.
3. Before replacing power head, refer to this manual
to ensure you have the proper filters installed for
the cleaning operation.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
5. Insert the end of the hose into the inlet of the tank.
6. Attach the extension wands to the end of the hose.
Apply slight pressure until fitting is tight.
7. Attach one of the cleaning accessories (depending
on the cleaning requirements) to the extension
wands. Twist slightly to tighten the connection.
8. Plug the cord into the wall outlet. The vacuum is
ready for use.
WARNING:
To reduce the risk of fire or explosion, do not operate
this vac in areas with flammable gases, vapors or
explosive dust in the air. Flammable gases or vapors
include but are not limited to: lighter fluid, solvent-type
cleaners, oil-based paints, gasoline, alcohol or aerosol
sprays. Explosive dusts include but are not limited
to: coal, magnesium, aluminum, and grain or gun
powder. Do not vacuum explosive dust, flammable or
combustible liquids or hot ashes. Do not use this vac
as a sprayer for any flammable or combustible liquid.
To reduce the risk of health hazards from vapors or
dusts, do not vacuum toxic materials.
WARNING:
SERVICING OF DOUBLEINSULATED WET/DRY
VAC
In a double-insulated Wet/Dry Vac, two systems of
insulation are provided instead of grounding. No
grounding means is provided on a double-insulated
appliance, nor should a means for grounding be
added. Servicing a double-insulated Wet/Dry Vac
requires extreme care and knowledge of the system
and should be done only by qualified service
personnel. Replacement parts for a double-insulated
Wet/Dry Vac must be identical to the parts they
replace. This double-insulated Wet/Dry Vac is
marked with the words "DOUBLE-INSULATED" and
the symbol (square within a square) may also be
marked on the appliance. To reduce the risk of injury
from electrical shock, unplug power cord before
servicing the electrical parts of the Wet/Dry Vac.
WARNING:
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or similary
qualified person in order to avoid a hazard.
WARNING:
Remove the plug from the socket before performing
maintenance. Before using the machine make
sure that the frequency and voltage shown on the
rating plate correspond with the mains voltage.
Specifications and details are subject to change
without prior notice. The accessories shown in the
pictures may vary from model to model.
IMPORTANT SAFEGUARDS
The symbol on the product or packaging indicates
that the product must not be treated as domestic
refuse. Instead, it should be handed in to a collection
point for the recycling of electrical and electronic
components. By ensuring the product is treated in
the right way, this will help to prevent the negative
impact on environment and health that may result
from the product being thrown away as general
waste. For further information about recycling, you
should contact the local authorities, refuse collection
service or the sales outlet where you bought the
goods.
PROTECTING THE ENVIRONMENT
Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal household waste. Products and
batteries contain materials that can be
recovered or recycled reducing the demand
for raw materials. Please recycle electrical products
and batteries according to local provisions. Further
information is available at www.2helpU.com.
6

Werbung

loading