PAYTEC N86 Anleitung Seite 4

Power on/off, Restart
Power on: Press the „ " button for 2-3
seconds to power on the terminal.
Power off or restart the terminal: Press
the „ " until the „Switch off; Restart" menu
is displayed. Select „Switch off" and the
terminal switches off. Select „Restart" and
the terminal restarts.
Magnetic Card: Swipe the card with consistent speed in the
magstripe card slot as demonstrated in the picture. While swi-
ping, make sure that the magstripe is facing the device.
Attention: Any damage to the magstripe or incorrect swiping may lead
to transaction failures.
Contact Card: The card slot is at the right side of the device.
Insert the card (golden contacts facing up) with gentle pressure
into the slot. During the transaction process, the card must
remain in the slot as shown in the picture.
Attention: If the chip contacts are damaged or oxidized, the transaction
may fail and the card needs to be replaced.
Contactless Card: The NFC field establishes at the top of the
device near the printer cover. For about one second, hold the
contactless card close to this zone until you hear a „beep" sound
which means a successfully completed transaction. After that
sound, the card can be removed.
4