Concept RK4190 Bedienungsanleitung Seite 15

EN
ACKNOWLEDGMENT
Thank you for purchasing a Concept product. We wish you much joy with your new appliance every day you use it.
Please read the instruction manual carefully before initial use. To refer to this manual any time you need to, we recom-
mend you to keep it in a safe place. And please pass it to any future owner of the appliance.
TECHNICAL SPECIFICATIONS
Voltage 220–240 V ~ 50/60 Hz
Input 1850– 2200 W
Volume 1.7 l
IMPORTANT SAFETY PRECAUTIONS
Do not use the appliance in any other way than as described in this
•
manual.
Remove all the covering and marketing materials from the appliance
•
before the first use.
Make sure the mains voltage corresponds to the values on the rating
•
plate of the appliance. Only use grounded sockets.
The appliance is hot during operation and for some time after
•
switching off. Therefore, do not touch hot surfaces. Due to the risk
of burning use only the handle and buttons.
Do not clean, store or cover the appliance until it has cooled
•
completely.
Do not leave the appliance unattended when it is switched on or
•
connected to the mains.
Never carry the appliance during operation or while it is still hot. Do
•
not carry it by the power cord.
Make sure the appliance is switched off before connecting or
•
disconnecting the appliance from the mains socket.
When disconnecting the appliance from the wall outlet, never pull
•
the power cord, grasp the plug end and disconnect it by removing
it from the receptacle.
Do not allow children or unauthorized people to handle the
•
appliance, use it out of their reach.
Persons with reduced mobility, reduced sensory perception, mental
•
disadvantage or persons not familiar with the operation must use
the appliance only under the supervision of responsible person,
who is familiar with the instructions.
Pay extra attention if the appliance is used near children.
•
Do not use the appliance as a toy.
•
28
Do not use any accessories other than those recommended by the
•
manufacturer.
Before cleaning and after use of the appliance, switch the
•
appliance off, disconnect it from the mains and allow it to cool
down.
Do not allow the power cord to hang freely over the edge of the
•
table. Do not allow the power cord to touch hot surfaces.
Only place the appliance on a stable and heat-resistant surface away
•
from other heat sources such as radiators, ovens, etc. Protect it from
direct sunlight and moisture.
There must be water in the appliance before connecting it to the
•
mains.
Do not add water when the appliance is on the base!
•
After filling the appliance with water, make sure that the bottom of
•
the appliance is dry. Wipe off any drops of water before placing the
appliance on the base.
The appliance may only be used for heating water up to the
•
recommended maximum – if the amount of water exceeds the
recommended maximum level, boiling water may splash out – RISK
OF SCALDING!
Before switching the appliance on, make sure that the lid is properly
•
closed. Do not open it during heating to avoid scalding.
We do not recommend using the appliance for heating liquids other
•
than water.
Do not switch the appliance on if there is no water in it. However, if
•
an empty appliance is switched on, the safety fuse will automatically
switch it off. Then let the appliance cool down, fill it with cold water
and you can use it again.
Care should be taken when opening the lid and refilling the hot
•
kettle with water – RISK OF SCALDING!
Take precautions when handling the appliance as to avoid scalding
•
with hot water. Always hold the appliance by the handle as the body
of the kettle may be hot and burn you.
Pour out the hot water slowly, excessive tilting may cause the water
•
to flow through the lid – RISK OF SCALDING!
Do not use coarse and chemically aggressive substances to clean
•
the appliance.
EN
29