cecotec READYWARM 6300 CERAMIC TOUCH Bedienungsanleitung Seite 14

ESPAÑOL
Datos de Grupo Cecotec Innovaciones S.L. · C/de la Pinadeta s/n 46930 Quart de Poblet,
contacto: Valencia (SPAIN)
READYWARM 6300 CERAMIC TOUCH
26
Otras opciones de control (pueden
seleccionarse varias)
Control de temperatura [no]
interior con detección
de presencia
Control de temperatura [no]
interior con detección
de ventanas abiertas
Con opción de control a [no]
distancia
Con control de puesta [no]
en marcha adaptable
Con limitación [no]
de tiempo de
funcionamiento
Con sensor de lámpara [no]
negra
1. PARTS AND COMPONENTS
Main body
Fig. 1.
1. Control panel
2. Display
3. Air vent
4. On/off switch
Control panel
Fig. 2.
1. Temperature/timer +
2. Temperature/timer -
3. On/off
4. Mode
5. Oscillation
2. BEFORE USE
Take the product out of the box.
Remove all packaging material Save the original box.
Make sure all parts and components are included and in good conditions. If any visible signs
of damage are observed, contact the Technical Support Service immediately.
3. OPERATION
Plug the device's power cord into an electrical outlet.
Turn on the main switch at the back of the device.
Press the on/off button to start the heater and press the mode button to select the desired
mode:
Fan mod
Low heat mode
High heat mode
Press the oscillation button to activate the 75º oscillation function.
Use the temperature + or temperature – buttons to set the desired temperature, from 16 ºC to
37 ºC.
Hold down the mode button for 5 seconds to activate the timer function. Then, use the
temperature + or temperature – buttons to set the timer. It can be set up to 9 hours, and the
device will automatically turn off after the set time. The display will blink 3 times when the
ENGLISH
READYWARM 6300 CERAMIC TOUCH
27