Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Operating mode DMX:
Connect the DMX input of your device to the DMX output of your DMX controller, your DMX
Connect the DMX input of your device to the DMX output of your DMX controller, your DMX
software or the DMX output of a device already in your DMX line. Always use a DMX cable with a
. Always use a DMX cable with a
110 Ohm resistor for this connection. Address the device according to your DMX configuration.
your DMX configuration.
The following table shows the respective DMX modes of the individual devices with the
The following table shows the respective DMX modes of the individual devices with the
corresponding values and functions:
For ideal operation in a DMX chain, it is recommended to use a terminating resistor at the end of
For ideal operation in a DMX chain, it is recommended to use a terminating resistor at the end of
each DMX chain. The terminating resistor is usually soldered with 120Ω between
ain. The terminating resistor is usually soldered with 120Ω between – Data and +
Data to prevent signal reflections.
Configuration oft he DMX connector:
Werbung
