Werbung
FRONT PANEL CONTROLS
REGLER DER FRONTPLATTE
COMMANDES
DE LA FACADE
@®
®
1. POWER switch
When this switch is pressed on (-—}, the indicators in the
display
window
light corresponding
to the
respective
switches engaged and the dots of the SPECTRUM
ANA-
LYZER light. Repressing the switch (.m) sets the POWER
OFF.
2. Microphone jack (MIC)
This is not for recording or mixing the microphone sound,
but to check the sound spectrum of musical instruments
or human
voice utilizing the built-in SPECTRUM
ANA-
LYZER.
3. MIC ATTENUATOR
switch
-20dB:
Set to this position when the sound source is
(-—-)
nected microphone is high.
O dB (.m@): Use this position for normal sound source
analysis.
4. MIC/LENE switch
MIC (-=): Set to this position when you are using a
microphone
— for
checking
the
sound
spectrum.
LINE:
Set to this position except when you are using
(mm)
a microphone.
excessively loud or the sensitivity of the con-
Fig. 2
Abb .2
5. DISPLAY
LEVEL control
re
Adjusts the relative display position on the SPECTRUM
ANALYZER
indicator so that even
low-level signals can
be displayed
in an easy-to-see position. This control has
no effect on the output sound level.
. SEA CHARACTER switch
REVERSE
(—): This
position
causes
reverse
control
characteristics,
which
is
useful
for
elimination
of tape
hiss
noise.
It is
especially
effective
when
using tapes
that will be recorded
and played back
with SEA compensation.
Refer
to
"application"
further details on page 13.
NORMAL
(81):
Set to this position for normal use.
SEA switch
DEFEAT:
For bypassing the SEA circuit.
(-— )
Convenient
for checking
the SEA-compen-
sated signal and
for a comparison
with the
original sound.
section
for
Werbung
