Periods Of Non-Operation; What To Do If - AEG S41540TSW1 Benutzerinformation

10 www.aeg.com
Defrost the freezer when the
frost layer reaches a thickness of
about 3-5 mm.
To remove the frost, do these steps:
1. Switch off the appliance.
2. Remove any stored food, wrap it in
several layers of newspaper and put
it in a cool place.
3. Leave the door open.
4. When defrosting is completed, dry
the interior thoroughly and refit the
plug.
5. Switch on the appliance.
6. Set the temperature regulator to ob-
tain the maximum coldness and run
the appliance for two or three hours
using this setting.
7. Reload the previously removed food
into the compartment.
Never use sharp metal tools to
scrape off frost from the evapo-
rator as you could damage it. Do
not use a mechanical device or
any artificial means to speed up
the thawing process other than
those recommended by the
manufacturer. A temperature rise
of the frozen food packs, during
defrosting, may shorten their
safe storage life.

8. WHAT TO DO IF...

WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual.
Problem
The appliance is
noisy

7.4 Periods of non-operation

When the appliance is not in use for
long periods, take the following precau-
tions:
• disconnect the appliance from elec-
• remove all food
• defrost (if foreseen) and clean the ap-
• leave the door/doors ajar to prevent
If the cabinet will be kept on, ask some-
body to check it once in a while to pre-
vent the food inside from spoiling in
case of a power failure.
Possible cause
The appliance is not sup-
ported properly
tricity supply
pliance and all accessories
unpleasant smells.
There are some sounds during
normal use (compressor, refriger-
ant circulation).
Solution
Check if the appliance
stands stable (all the four
feet should be on the
floor)