EINHELL TP-CL 18/3000 Li Originalbetriebsanleitung Seite 12

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols used (see Fig. 12)
1. Danger! - Read the operating instructions to
reduce the risk of injury.
2. Caution! Do not look into the light beam.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
2. Layout and items supplied
2.1 Layout (Figs. 1/2/9/10/11)
1. Carry-handle
2. Lamp head
3. Lateral lamps
4. On/Off switch
5. Battery mount
6. Fastening screw
7. Foot
8. Hook
9. Serrated edge
10. Suspension eyelet
11. Socket with ⅝ inch thread
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
Anl_TP_CL_18_3000_Li_Solo_SPK13.indb 12 Anl_TP_CL_18_3000_Li_Solo_SPK13.indb 12
GB
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Battery-powered lamp
•
Original operating instructions
3. Technical data
Power supply of rechargeable battery: ... 18 V DC
Number of LEDs ............................................ 60
Light fl ux: ................................................ 3000 lm
Weight: .......................................................1.7 kg
Caution
The equipment is supplied without batteries and
without a charger. It must only be used with the li-
thium-ion batteries in the Power X-Change series.
The lithium-ion batteries of the Power X-Change
series must only be charged only with the Power
X-charger.
4. Operation
4.1 Charging the lithium-ion battery pack
(Fig. 3/4)
1. Pull the battery pack (a) out of the battery
mount (5), pressing the pushlock button (b)
downwards as you do so.
2. Check that your mains voltage is the same as
that marked on the rating plate. Insert the po-
wer plug of the charger into the power socket.
The green LED will begin to blink.
- 12 -
31.10.2023 08:49:05 31.10.2023 08:49:05