BWT RC30 Bedienungsanleitung Seite 6

Maintenance and Storage
Cleaning the filters
The filter(s) must be cleaned after each cleaning cycle. Press the button
to release the lid and pull out the filter(s). Spray water on the outer sides
of the filter and then spray water towards the inner side of the filter to
clean all the dirt and debris. Reinsert the filter(s).
Storing the robotic cleaner
Follow these instructions to store the robotic cleaner when not in use:
Disconnect the power cord from the wall outlet. Disconnect the floating
cable from the power supply. Make sure that the power supply is not
exposed to water. Spread out the floating cable and roll it. Wash the
interior and exterior of the cleaner unit with fresh water and let it dry.
Roll the floating cable and place it on the cleaner unit. Caution: Store the
robotic cleaner components in a dry, closed location.
Checking water outlet propeller
It is recommended to periodically clean debris and hair from the
propeller of the water outlet: (1) Unscrew the outlet locker that secures
the outlet cover. (2) Remove the water outlet cover (3) Clean any hairs,
dirt, or debris. (4) Return the outlet locker resecuring the outlet cover.
Single or double filter depends on the model
6
RC30 | RC40 ROBOTIC POOL CLEANER