Herunterladen Diese Seite drucken

BWT RC30 Bedienungsanleitung Seite 4

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 15
Operation
Please use as much cable as
needed. Leave the remaining
cable out of the pool.
You may turn on
the cleaner when it
reaches the floor.
3.6 m / 11.8 ft
4
RC30 | RC40 ROBOTIC POOL CLEANER
Placement of the Power Supply
Place the power supply at least 3.6 meters / 11.8 feet from the pool and
at least 12 cm above ground. CAUTION: The power supply is not water
resistant; it must not be exposed to water or to direct sunlight.
Press the plastic snap on the zip ties in order to release the floating cable.
Use as much cable as needed in the water.
Before placing the cleaner unit in the water
Make sure there are no people in the pool. Make sure that the filters are
clean. Make sure the pool conditions are met; (see "Operating Conditions").
Placing cleaner in the water
Unroll the floating cable. It is recommended to extend a length of cable
that is equal to the diagonal size of the pool plus an additional two meters.
Smooth out coils or twists in the cable. Connect the floating cable to the
socket located on the power supply. Roll extra cable, not in the pool, near the
power supply. Place the robotic cleaner in the pool. Let it sink to the bottom
of the pool. Do not start operation before the robotic cleaner is settled on
the pool floor. CAUTION: Operating the cleaner out of water may cause
12 cm / 4.7 inch
immediate and severe damage resulting in loss of warranty.
above ground
Starting the robotic cleaner Connect the power supply to the wall socket.
The on/off button will light up and the robotic cleaner will start its cleaning
program. If the power supply is already connected to the wall socket, the
on/off button will flash to indicate that the robotic cleaner is in standby
NO SWIMMING
mode. Press the On/Off button in order to change the above mode (On
WHILE THE ROBOT
to Off – standby, or vice versa). Note: if the full filter indication light (only
IS IN THE POOL
available on some models) is ON make sure to remove and clean the filter
prior to putting the cleaner back in the pool.

Werbung

loading

Diese Anleitung auch für:

Rc40