Troubleshooting - for_q FQ-ARM 4038 BASIC Bedienungsanleitung

Troubleshooting

Caution! Make sure the appliance is switched off and the battery is
removed. Always wear protective gloves.
Problem Possible cause
Motor does Battery empty
not run
Unsuitable cutting areas
Blade is blocked
Safety plug is not con-
nected
Battery is not correctly
inserted
Wrong cutting height
Motor power Wrong cutting height
drops
Discharge chute is
blocked
Poor and uneven cut
Collection Unsuitable cutting areas
bag is not
filled suitably
Poor and uneven cut
Collection bag is full
Discharge chute is
blocked
Solution
Recharge battery
Start on short or already
mown grass.
Clean discharge chute and
housing (blade must rotate
freely)
Connect safety plug
Remove battery and insert
again
Set the wheels to the correct
cutting height
Set the wheels to the correct
cutting height
Clean discharge chute and
housing (blade must rotate
freely)
Replace the blade (contact
service center)
Set the wheels to the correct
cutting height
Allow lawn to dry
Replace the blade (contact
service center)
Empty the collection bag
Clean discharge chute and
housing (blade must rotate
freely)
EN
105