Scheppach JCL150 Originalbetriebsanleitung Seite 22

b) Do not use the power tool if the switch does
not turn it on and off. Any power tool that can-
not be controlled with the switch is dangerous and
must be repaired.
c) Disconnect the plug from the power source
and/or remove the battery pack, if detachable,
from the power tool before making any adjust-
ments, changing accessories, or storing pow-
er tools. Such precautionary measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of chil-
dren and do not allow persons unfamiliar with
the power tool or these instructions to operate
the power tool. Power tools are dangerous in the
hands of untrained users.
e) Maintain power tools and accessories. Check
for misalignment or binding of moving parts,
breakage of parts and any other condition that
may affect the power tool's operation. If dam-
aged, have the power tool repaired before use.
Many accidents are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the power
tool for operations different from those intended
could result in a hazardous situation.
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unexpected
situations.
5. Service
a.) Only have your electric tool repaired by qual-
ified specialists and only with original spare
parts. . This will ensure that the safety of the pow-
er tool is maintained.
Further safety instructions
• If the mains connection cable of this device is dam-
aged, it must be replaced by the manufacturer, their
service department or a similarly qualified person to
avoid dangers.
• Switch off the motor and disconnect the mains plug:
- in the event of accidents or malfunctions,
- when you are not using the device,
22 | GB
- when you are leaving the device unattended,
- when cleaning, maintaining or before testing the
device,
- when transporting the device from one place to
another,
- Remove or replace the working brush.
• Brushes must not be fitted on machines whose
speed is higher than the maximum permissible
brush speed.
• Damaged brushes must not be used.
• Rust discolouration or other signs of chemical or
mechanical alteration to the trim material may cause
premature failure of the brush.
• Brushes must be stored in suitable racks, contain-
ers or boxes in such a way that they are protected
against the following effects:
- High humidity, heat, water or other liquids that
could cause damage to the brush
- Acids or vapours of acids that could cause dam-
age
- Temperatures so low that they could lead to con-
densation on the brushes if they are moved out to
an area with higher temperatures
- Deformation of the brush components
• Do not use accessories that are not recommended
by the manufacturer. This can lead to electric shock
or fire.
Residual risks
The power tool is state-of-the-art and has been
built according to the recognised technical safety
regulations. However, individual residual risks can
arise during operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Important in-
formation" and the "Proper use" are observed along
with the whole of the operating instructions.
• Avoid accidental start-ups of the machine: the start
button may not be pressed when inserting the plug
in a socket.
• Keep your hands away from the working area when
the machine is in operation.
• Before performing setting or maintenance work, re-
lease the start button and pull out the power plug.
www.scheppach.com