Werbung
Verfügbare Sprachen
Verfügbare Sprachen
checking function on the tool.
Shaft lock (Fig. 1)
CAUTION:
• Never actuate the shaft lock when the spindle is
mov ing. The tool may be damaged.
Press the shaft lock to prevent spindle rotation
when installing or removing accessories.
Switch action (Fig. 2)
CAUTION:
• Before plugging in the tool, always check to see
that the slide switch actuates properly and re-
turns to the "OFF" position when the rear of the
slide switch is depressed.
To start the tool, slide the slide switch toward the
"I (ON)" position. For continuous operation, press
the front of the slide switch to lock it.
To stop the tool, press the rear of the slide switch,
then slide it toward the "O (OFF)" position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing side grip (handle) (Fig. 3)
CAUTION:
• Always be sure that the side grip is installed se-
curely before operation.
Screw the side grip securely on the position of
the tool as shown in the figure.
Installing or removing wheel guard (Fig. 4 &
5)
CAUTION:
• When using a depressed center grinding
wheel/Multi disc, flex wheel, wire wheel brush,
cutoff wheel or dia mond wheel, the wheel
guard must be fitted on the tool so that the
closed side of the guard always points toward
the operator.
Mount the wheel guard with the protrusion on
the wheel guard band aligned with the notch on
the bearing box. Then rotate the wheel guard
around 180 degrees. Be sure to tighten the
screw securely.
To remove wheel guard, follow the installation
procedure in reverse.
Installing or removing depressed center
grinding wheel/Multidisc
WARNING:
• Always use supplied guard when depressed
center grinding wheel/Multidisc is on tool.
Wheel can shatter during use and guard
helps to reduce chances of per sonal injury.
Mount the inner flange onto the spindle. Fit
the wheel / disc on the inner flange and screw
the lock nut onto the spindle. (Fig. 6)
To tighten the lock nut, press the shaf t lock
firmly so that the spindle cannot revolve, then
use the lock nut wrench and securely tighten
clock wise.
To remove the wheel, follow the installation
procedure in reverse. (Fig. 7)
WARNING:
• Only actuate the shaft lock when the spindle
is not moving.
OPERATION
WARNING:
• It should never be necessary to force the tool.
The weight of the tool applies adequate pres-
sure. Forcing and excessive pressure could
cause dangerous wheel breakage.
• ALWAYS replace wheel if tool is dropped while
grind ing.
• NEVER bang or hit grinding disc or wheel onto
work.
• Avoid bouncing and snagging the wheel, espe-
13
Werbung
