Cloer 3609 Bedienungsanleitung Seite 7

Description
1 Lift button (ON/OFF switch)
2 Defrost button
3 Infinitely variable browning control
4 Stop button
5 Crumb tray
6 Bun warmer
Setting up and connecting /
Before using the first time
·
Read these instructions carefully before using
the first time.
·
Remove all packaging parts and, if applicable,
stickers, not the identification plate.
·
Put the toaster on a dry, anti-grip and even
base.
·
The first operation can cause a slight development
of smell. This is why we recommend you to
operate the appliance in a well-aired room at the
beginning without toasting material one or two
times at highest level.
Safety instructions for operation
The appliance meets the
requirements of the applicable
EC directives.
The appliance is intended
for in door use only.
·
Never leave your toaster unattended if it is in
operation.
·
Do not let mains cable hang down e.g. at corners
or edges.
ATTENTION! The heating wires
inside are electrically active
during operation! Do not reach
into the toaster or insert any
objects, especially any metal
(fork, spoon) into it. Risk of
electric shock when touching it!
·
If the lever key is stuck, the toaster cannot
automatically switch off. See to it that the lift
key is freely moving.
·
Please note that your toaster has a heavy
upwards heat emission. Therefore, always see
to it that your toaster is never put near objects
of paper, fabric or similar.
·
The bread grooves must not be covered up.
·
Never use the toaster without crumb tray.
·
This toaster is not suitable for toasting bread
such as crispbread, rusk or similar.
·
Assure that the cable never comes into contact
with hot areas.
·
Dry bread browns faster than fresh one.
·
The browning control serves for the individual
setting of the browning degree.
·
If toasting only one slice of bread you should
choose a low browning degree.
·
Never use the toaster lying on its side.
ATTENTION!
Always unplug appliance when
not in use and before cleaning!
Start-up and operating
instructions
·
Plug mains plug into power socket.
·
Place slices of toast or bread in the toast
compartments. Do not use slices that are too
large or too thick. The slice of toast must not get
stuck in the shaft.
·
Set the required degree of browning between
1 and 7.
·
Try browning setting at first as the degree of
browning depends on the toast bread and its
humidity.
·
Press the toast lever down until it clicks. Your
toaster is in operation and the STOP button
lights up.
·
Note: If the toaster is not plugged into the
mains, the bread lever does not click into place
as it is electro-magnetically retained.
·
The browning process can be interrupted at any
time by pressing the "STOP" button.
·
Advice: Please postion each slice of toast
always in the middle of the bread slots to allow
the slice of toast being consistently toasted
from all sides.
Integrated attachment for buns
·
The attachment for buns makes buns of the
previous day oven-fresh and crispy again.
·
Fold out the attachment for buns by means
of the lateral key and toast both sides of your
buns.
·
Set the control to the bun icon.
·
Finally fold the attachment for buns again.
STOP button
STOP
You can push your toaster's stop button at any
time to interrupt the toasting process.
Defrost button
Use the defrost button to toast frozen bread. To
retain the usual degree of browning, push the
defrosting button after pushing the lift button
down and before it comes back up.
Cleaning
·
Unplug power plug before cleaning and let
appliance cool down.
EN
7