HEYLO PV 6000 Betriebsanleitung Seite 28

Fan PV 6000
a) Check the scope of delivery for completeness.
Report any transport damage or an incomplete
delivery to your dealer immediately.
b) Dispose of the packaging in accordance with
the applicable local regulations.
c) If necessary, lift the device using the carrying
handle and then place it on the ground.
d) Move it to its installation site.
e) Ensure that you adhere to the Operating condi-
tions [ 22].
f) Make sure the power cable is undamaged.
g) Insert the mains plug in a mains socket.
h) Make sure the device is securely fastened in
place, cannot move and will not tip over either in
operation or otherwise.
 The device is then set up and installed. Air hos-
ing can be attached to extract the exhaust air
(see theAccessories list).
16 Commissioning and
operation
WARNING
Risk of injury and hearing damage
The device can throw around particles from the
environment and cause sound emissions in opera-
tion (see Technical details).
a) Wear hearing protection and safety goggles.
Commissioning
a) Make sure that the device is not standing on a
wet base and ensure that it stands upright and
safe.
b) Use the arrow on the device housing to check
that the fan is turning in the correct direction by
briefly switching the device on and immediate-
ly off again on the device switch.
Switching the device on
a) Turn the device switch ON.
 The continuous operating mode will start and
the device will run until turned off using this
switch.
 The device is now switched on.
26 / 36
Switching the device off
a) Turn the device switch OFF.
 The device is now switched off.
See also
 Safety [ 21]
EN