HEYLO PV 6000 Betriebsanleitung Seite 27

set-up, maintenance or repair work and must be
reinstalled before restarting.
The device has the following safety covers:
– Protective grille preventing access installed in
front of the turbine blade (air intake end).
– Protective grille preventing access installed in
front of the air outlet.
– Protective cover on the electrical components
14.4 Operating and display elements
The device is operated solely with the device switch
on the back of the device. The device switch turns
the device on and off.
EN
See also
 Safety devices [ 24]
15 Transport and
installation
The device has been assembled, set up and tested
at the factory. In order to rule out any life-threatening
injuries and damage to materials during transport
and installation, please observe the following:
– Transport and installation work may only be car-
ried out by qualified and authorised persons.
– Transport routes must be large enough.
– Adhere to the Operating conditions
the differing sorts of danger.
DANGER
Danger to life due to electric shock
Touching electrically live parts can be fatal.
a) Always turn the device off at the device switch
before any change of location and disconnect
the mains plug.
b) Never pull the device by the mains plug cable;
always move it by the handle provided.
DANGER
Danger to life due to electric shock or de-
vice fire due to short circuit
Electronic rpm controllers increase the risk of fire
and short circuit.
a) Never use any electronic rpm control means.
CAUTION
Risk of injury due to the device tipping
over.
If the device tips over or falls during transport, you
may be injured.
a) Secure the device from falling or sliding over
during transport.
b) Wear safety shoes and protective gloves.
c) Use the handle provided to move the device.
Fan PV 6000
[ 22] and
25 / 36