HEYLO PV 6000 Betriebsanleitung Seite 25

Only original spare parts or parts approved by the
manufacturer may be used.
The following conditions and safety rules must al-
ways be adhered to.
– Always handle the device with care. Never drop
the device, throw it or transport it in any vehicle
without securing it properly.
– The device must be installed upright and stable.
It must not fall over or slip even under full load.
– Do not cover the device during operation.
– The device must not be operated in puddles or in
stagnant water. If the device or the connection
cable gets wet then it must be dried thoroughly
before the device may be operated.
– Make sure that the device does not suck in any
oil, grease or other contaminant.
– The mains voltage must correspond to the de-
tails on the rating plate.
– Extension cables must be selected according to
the performance data on the rating plate, in or-
der to prevent overload.
– The socket used must be earthed or protected
with a current operated earth leakage circuit
breaker when installed indoors.
– Never operate the device unattended.
– People under the influence of alcohol, drugs or
medication must not operate or maintain the de-
vice.
13.2 Personal protective equipment
Personal protective equipment serves to protect staff
against any hazards that could affect their safety or
health at work.
The following personal protective equipment must
be worn during transport and installation:
– Protective gloves to prevent the hands becoming
crushed or trapped
– Safety shoes to protect against impacts or falling
over
During operation must be worn:
– eye protection against airborne particles.
– ear defenders against noise.
EN
14 Product description
14.1 Identification of the machine
The device can be clearly identified with the rating
plate on the back of the device.
Rating plate
The rating plate contains the following device infor-
mation.
The rating plate contains the following device infor-
mation.
– Model
– Rating number
– Serial number
– Electrical connection information
– Performance data
14.2 General description
The device is the ideal tool for use in industry and
trade. It is suitable for ventilation when working in
shafts, for drying cavity spaces after water damage
or for air extraction when welding in tanks and con-
tainers. The device components are quick to as-
semble, the hose is quick to connect to the air outlet
or suction end and everything can be packed away
safely after work. Due to its high protection class,
the device is especially suitable for outdoor use and
on building sites.
The device must only be used:
– for the purpose for which it was intended,
Fan PV 6000
23 / 36