EuroLite LED Bar 384 RGB 5mm Lighting Effect Bedienungsanleitung Seite 24

OPERATION
After you connected the effect to the mains, the EUROLITE LED Leiste 384 RGB 5mm starts running.
Attention: After every 8 LED Bar 384 RGB 5mm, the fixtures must have a renewed connection with the
power mains.
Stand Alone operation
In Stand Alone mode, the LED Bar 384 RGB 5mm can be used without controller as the device features a
built-in microphone, which provides automatic sound control.
Disconnect the EUROLITE LED Bar 384 RGB 5mm from the controller.
Please refer to the instructions under Control Board.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the EUROLITE LED Bar 384 RGB 5mm you can find an XLR-jack (DMX Out) and an
XLR-plug (DMX In), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a balanced microphone lead.
Connect the DMX OUT jack with the DMX IN plug of the next device.
Please refer to the instructions under Control Board.
24/30 00043903.DOC, Version 2.0