Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.4.4 Fit seal (I) to exterior frame. Position exterior frame on outside of door.
Screw interior frame to it by using 37mm (1
(Fig. 10 and 11).
8.5 For door panels 25mm (1") + thick:
8.5.1 Carefully drill out four holes in interior frame to allow close clearance on
screws (recommended drill 5mm (
8.5.2 Fit seal (I) to exterior frame. Screw exterior frame to outside of door using
13mm (
8.5.3 Screw interior frame to inside of door using 22mm (
screw caps.
Walls / Glass Panels
For easy installation you will require an adapter kit available from your cat flap supplier
or direct from Closer Pets (Product Ref. 387).
9. Troubleshooting
9.1 Cat's microchip will not program
• Your cat's microchip might be faulty or poorly positioned. Contact Closer Pets
Customer Services or use a Cat Mate I.D. Disc.
9.2 Red LED (A) flashing
• 1 flash every 30 seconds indicates need to replace alkaline batteries.
9.3 Flap does not open in response to programmed microchip or I.D. Disc
• Check catch (C, Fig. 1) moves freely up and down when cat's head is pushed
gently against the flap as shown in Fig. 2.
• Check 4 WAY lock is set to permit access in the chosen direction.
• Check I.D. Disc, if used, is correctly fitted to cat's collar.
• If possible, try operation with another programmed microchip / I.D. Disc to
ascertain if there is a fault with a particular microchip / I.D. Disc.
• For UPVC / metal panels over 35mm (1
correctly with adapter kit and circular cut out.
• For UPVC / metal panels check cat flap has been retuned after fitting (See
Section 8).
• Check batteries are correctly orientated and not in need of replacement (See
Section 6).
• Check cat flap is mounted at correct height (See Section 8).
• If all above fails, remove one battery and wait a minimum of 1 hour. Refit battery
and then check if flap functions correctly. If not perform a FACTORY RESET (See
Section 7) before reprogramming (See Section 3).
• It is possible that your cat has a 'low power' microchip and the flap requires
setting to low power. The cat flap is supplied to suit the vast majority of standard
microchips.
To change from standard microchip setting to low power setting please contact:
Closer Pets Customer Services on
+44 (0)1932 700 001 · N America (936) 760 4333
/
") screws.
1
2
or email help@closerpets.com
/
") screws. Finally, fit screw caps
1
2
/
") diameter) as shown in Fig. 12.
3
16
/
") thick check cat flap has been fitted
3
8
9
/
") screws. Finally, fit
7
8
Werbung
