Closer pets 360 Betriebsanleitung Seite 6

IMPORTANT SAFETY INSTRUCTIONS
• Read all instructions before installing or using this product.
• Register your purchase on-line at www.closerpets.com (see guarantee).
• Do not allow children to play with this product.
• Inspect product regularly for correct operation and damage. Do not use if in doubt.
• This product is designed for use with pets only, as described in these instructions.
• The locking system of this pet door is not intended as a security device.
• This pet door is not a fire resistant door and must not be used where there is a risk
from fire spread.
• The installer of this pet door is responsible for complying with all relevant building
regulations.
• During installation of this pet door take appropriate care. Follow safety instructions for
all tools and wear appropriate personal protective equipment.
• Dispose of all packaging material properly. NOTE: Plastic bags could cause
suffocation - keep away from children and animals.
IMPORTANT:
• Do not cut tunnel (B, Fig. 1) of cat flap.
• To check that your cat's microchip is correctly positioned and functioning, we
strongly recommend you program the cat flap for all your cats before installation
(see Section 3). Then check the cat's operates the catch (C, Fig. 1) when the cat's
head is pushed gently against the flap as shown in Fig. 2.
• For UPVC / metal doors thicker than 35mm (1
Kit (Ref. 387).
• For UPVC / metal doors it is essential to retune the cat flap after fitting (see
Section 8).
1. Introduction
Thank you for choosing the Cat Mate Microchip Cat Flap.
The Cat Mate Microchip Cat Flap allows entry for up to 30 cats into your property. It also
allows you to control the exit of all your pets using a 4 way lock.
This cat flap is suitable for all popular microchips. Alternatively it may be operated by
a Cat Mate I.D. Disc (available separately). You may wish to use an I.D. Disc for cats
without a microchip or in the event that your cat's microchip is faulty or poorly positioned.
2. Fitting the Batteries
2.1 Remove the battery cover by pushing the battery cover upwards (see Fig. 3).
2.2 Insert 4 x AA (R6) batteries using the orientation symbols marked on the inside of
the battery compartment. Partially replace battery cover to leave PROGRAM button
(G, Fig. 1) exposed for programming.
2.3 The cat flap will self check for up to 30 seconds and then the flap is ready to
program.
SAVE THESE INSTRUCTIONS
") use a Cat Mate Cat Flap Adapter
/
3
8
6