Closer pets 360 Betriebsanleitung Seite 8

6. Battery Replacement
When the LED flashes every 30 seconds, alkaline batteries should be replaced
(See Section 2).
Please note, after fitting new batteries the Battery warning may take up to 15 minutes
to disappear.
7. Factory Reset
To erase all programmed microchips / I.D. Discs, press and hold the 'PROGRAM' button
for 60 seconds. After a further 30 seconds you may re-programme microchip(s) / I.D.
Disc(s) (See Section 3).
8. Fitting Instructions (See Figs. 6 to 10)
IMPORTANT:
• Do not cut tunnel (B, Fig. 1) of cat flap.
• To check that your cat's microchip is correctly positioned and functioning, we
strongly recommend you program the cat flap for all your cats before installation
(See Section 3). Then check the cat's microchip operates the catch (C, Fig. 1)
when the cat's head is pushed gently against the flap as shown in Fig. 2.
• For UPVC / metal doors thicker than 35mm (1
Kit (Ref. 387).
• For UPVC / metal doors it is essential to retune the cat flap after fitting
(see below).
UPVC / Metal Doors
Doors constructed with metal panels may reduce the range of the microchip reader. You
may test for metal panels by drilling a small trial hole in the middle of the intended cat
flap location.
For correct operation it is important to ensure correct cut out size is made.
For UPVC / metal panels thicker than 35mm (1
Adapter Kit (available separately).
For UPVC / metal panels up to 35mm (1
After fitting, ensure the flap is tuned to the metal panel by pressing the PROGRAM button
(G) for 5 seconds until LED (A) lights. After 10 seconds press the PROGRAM button
again to complete retuning.
Wooden Doors
8.1 Place the exterior frame (frame without swing flap) in desired position on panel and
draw round the inside of the tunnel section as shown in Fig. 6. We recommend the
bottom of the hole is approximately level with your pet's stomach.
8.2 Use an electric jigsaw to cut 5mm (
square to the door, particularly with thicker doors. Ensure frames are free-fitting
in hole.
8.3 Determine thickness of door panel.
8.4 For door panels 3mm (
8.4.1 Position exterior frame on outside of door and mark four screw positions
(Fig. 7).
8.4.2 Remove frame and carefully drill screw clearance holes square to panel at
6mm (
8.4.3 For panels less than 17mm (
frame (F) as shown in Fig. 9 with a hacksaw or plastic cutting disc.
/ ") - 25mm (1") thick:
1
8
/ ") diameter (Fig. 8).
1
4
") use a Cat Mate Cat Flap Adapter
/
3
8
/ ") use a Cat Mate UPVC / Metal Door
3
8
/ ") thick proceed as for Wooden Doors below.
3
8
") outside of drawn line. Be careful to cut hole
/
3
16
") thick, carefully cut excess liner from exterior
/
5
8
8