Bosch 6 Serie Gebrauchsanleitung Seite 42

en Timer
Setting
Accessory
Sound
Quick access Activate or deactiv-
Unit
Brightness
Idle mode
Standby time Set the time after
Restore the
factory set-
tings
Appliance in-
formation
9 Timer
Ti m e r
You can use the timer to set the re-
Ti m e r
quired processing time.
9.1 Setting the processing
time
In the main menu use
1.
select "Timer" and confirm with
Use or to set the minutes and
2.
confirm with
42
Description
Activate or deactiv-
ate available access-
ory. The activated
accessory appears
in the main menu
and additional auto-
matic programmes
are available.
Set the volume of the
audible signals and
button tones.
ate automatic taring
of the scales.
Set the units for the
scales.
Select the brightness
of the display.
Set the time after
which the display
switches off.
which the appliance
switches to power
saving mode.
Reset appliance to
the factory settings.
Information about the
appliance software.
or
⁠ .
Use
3.
and confirm with
a The display shows "Select setting"
and the processing time selected.
Set the rotary switch to the re-
4.
quired speed.
a The display shows the speed se-
lected and the remaining pro-
cessing time.
a Once this time has elapsed, the
appliance stops processing and
the display shows "Set level" ⁠ .
Set the rotary switch to
5.
10 Scales
Sc a l e s
Your appliance is equipped with built-
Sc a l e s
in scales.
The main unit has 4 weight sensors
in its feet.
The following factors can falsify the
measuring result:
¡ Feet not standing on the work sur-
face properly
¡ Work surface vibrating
¡ Objects underneath the main unit
¡ Ingredient quantities less than 5 g
or 0.01 lb
¡ Main unit slipped
¡ Main unit touched
Tip: When "Quick access" is activ-
ated in the basic settings, the scales
will start automatically. Whenever the
appliance is plugged in, is woken
from power saving mode or if pro-
cessing ends, the scales will calib-
rate themselves and the display
shows "0" and the preset unit.
10.1 Weighing ingredients
In the main menu use
1.
select "Scale" and confirm with
to
⁠ .
a The scales will be calibrated.
a The display shows "0" and the pre-
set unit.
or to set the seconds
⁠ .
⁠ .
or to
⁠ .