Bosch 6 Serie Gebrauchsanleitung Seite 39

To change the setting, turn the tool
2.
in the desired direction.
→ Fig. 5
Observe the table:
Optimum set-
ting
Turn clockwise
Turn anticlock-
wise
Press the release button and push
3.
the swivel arm down until it en-
gages.
Check the setting.
4.
Press the release button and raise
5.
the swivel arm until it engages.
Hold the beating whisk at the bot-
6.
tom with one hand and tighten the
lock nut anticlockwise using a
spanner wrench.
5.10 Safety systems
You can find an overview of your ap-
pliance's safety systems here.
Start lock-out
Start lock-out prevents your appli-
ance from being switched on acci-
dentally.
The appliance can only be switched
on and operated if one of the
following conditions is satisfied.
¡ The swivel arm is correctly en-
gaged in a horizontal position.
¡ The swivel arm is correctly en-
gaged in a vertical position and
the protective drive cover or any
assembled accessory is secured
correctly.
Restart lock-out
Restart lock-out prevents your appli-
ance from automatically restarting
processing after a power failure.
The tool is
touching the
bowl lightly.
Lift tool
Lower tool
Before using for the first time en
The appliance is switched on again
after a power failure. Processing can-
not start again until the rotary switch
has been set to
Overload protection
The overload protection system pre-
vents the motor and other compon-
ents from being damaged through
being overloaded.
Signal tone
In case of a malfunction or if a safety
system switches off the appliance, a
signal tone is output.
Possible malfunctions included the
pivot arm not being correctly en-
gaged or the appliance overheating.
→ "Troubleshooting", Page 47
6 Before using for the
f i r s t t i m e Be f o r e us i n g f o r t h e
first time
Prepare the appliance for use.
Be f o r e us i n g f o r t h e f i r s t t i m e
6.1 Cleaning the appliance
and parts before using for
the first time
Press the release button and raise
1.
the swivel arm until it engages.
Turn the bowl clockwise and re-
2.
move.
Clean all parts that come into con-
3.
tact with food before using for the
first time.
→ "Cleaning and servicing",
Page 44
Put the cleaned and dried parts
4.
out ready for use.
⁠ .
39