Atag Zone Manage Installationsanleitung Seite 2

GB
overview
INDEX
Overview
CE labelling .........................................................................................2
Safety standards ...............................................................................3
Product description
Introduction .......................................................................................4
Technical data ....................................................................................4
Dimensions .........................................................................................5
Installation
Before installing the appliance ....................................................6
Wall installation .................................................................................6
Hydraulic diagram ............................................................................7
Electrical connections .....................................................................9
Electrical connection of the Zone manager ........................11
Preparing the boiler for operation
Control unit programming ........................................................12
Initialisation .....................................................................................12
Configuring the module .............................................................12
Air purge ...........................................................................................12
Frost protection function ...........................................................12
Anti-jamming function ................................................................12
Addressing the system interface .............................................13
Meaning of the LEDs ....................................................................13
Troubleshooting guide................................................................14
Thermoregulation
Temperature control ....................................................................15
Settings
....................................................................................16
2
Overview
This manual is an integral and essential part of the appliance.
Read the instructions and warnings contained in this manual
carefully; they provide important rules on installation,
operation and maintenance safety.
The technical notes and instructions in this document
are intended for installers so that they may carry out
this procedure correctly, in accordance with standard
procedures.
The control unit is designed to control multizone/
multitemperature heating systems. The use of the appliance
for purposes other than those specified is strictly forbidden.
The manufacturer shall not be held responsible for any
damage caused by improper, incorrect or unreasonable
use of the appliance or by the failure to comply with the
instructions provided in this manual. The installer must be
qualified to install heating appliances on completion of
which task the abovementioned technician must issue the
customer with a declaration of conformity.
Installation, maintenance and all other
must be carried out in full conformity with current
legal regulations and any instructions provided by the
manufacturer.
Incorrect installation can harm persons, animals and
possessions; the manufacturing company shall not be held
responsible for any damage caused as a result.
If any parts are not supplied or if the appliance is damaged,
please contact your supplier. Keep all packaging material
(clips, plastic bags, polystyrene foam, etc.) out of reach of
children as it may present a potential hazard. Before using
the control unit, make sure mains power supply is switched
off. All repairs must be carried out by a qualified professional
using only original spare parts. Failure to comply with the
above instructions could compromise the safety of the
appliance and void all liability on part of the manufacturer.
To clean external parts, switch off mains power. Clean using
a dampened cloth. Do not use aggressive detergents or
toxic products.
CE labelling
The CE mark guarantees that the appliance conforms to the
following directives:
- 2004/108/EC
relating to electromagnetic compatibility
- 2006/95/EC
relating to electrical safety
interventions