Atag ENERGION IDU M HYBRIDzone Schnellanleitung Seite 23

ENERGION IDU M HYBRIDzone
Electrical wiring
1.
BOILER BUS
1. Boiler bus connection
2. Heat pump bus connection
3. Anode electrical connection
4. Room thermostat zone 1
5. Room thermostat zone 2
6. Outdoor temperature sensor
7. Tank temperature sensor
8 Sensys Bus connection
9 AUX Input 1 Programmable Input (Par. 1.1.3)
10 Floor heating system safety thermostat (230V)
First installation
System dearation
Before switch on the heating system, a complete deareation
of the system is needed.
To activate the dearation cycle push for 5 seconds the but-
ton „ / " on the boiler panel or activate the function by
the parameter 1.12.0. on the sensys control.
Repeat the operation if needed.
OPEN ATG BUS ANODE TA1
EBUS2
TA2 SE TNK
THERM
B T
GND BUS
+24V GND
2. 3. 4. 5. 6. 7. 8.
TA1 TA2 SE
system interface
TANK
G S
ATG BUS
IN IN AUX OUT OUT HV
2 STE BUF
AUX2
AUX 1 AUX1 IN1
9. 10. 11. 12. 13. 14.
PAR. PAR.
1.2.0 1.2.1
buffer
HV
IN1
230 V N
L
11 Buffer temperature sensor
12 Foult alarm signal (set param. parametro 1.2.1)
13 Foult alarm signal (set param. 1.2.0)
14 Low tariff contact
15 DLSG contact (not active)
16 Auxiliary pump electrcal supply (230V)
17. Sanitary diverter valve connection (230V)
18. Cooling diverter valve connection (230V)
19 Hybride module electrical supply
HV OUT OUT PM AUX V1 V2
IN2 AUX4 AUX3 ⏚
N L LC N LO LC N LO
15. 16. 17. 18. 19.
PM
AUX
L N
HV
IN2
EN / 23