urmet 1067 Bedienungsanleitung Seite 4

MAINS AND BATTERY CONNECTION
The connection must be carried out with a sheathed cable with 3 conductors (line – neutral – earth).
Remove the sheath from the cable and connect the conductors L, N and Earth to the correspondent
terminals on the AC/DC converter. Then, fasten the cable properly with a small band.
For the supply cable, a manually operated power supply switching device externally to the control panel
must be used; this switching device must have a 3 mm minimum distance between contacts.
The switching equipment must disconnect simultaneously the Line and the Neutral conductor.
B
1. To make the ground connection of the equipment, crimp the spade terminal "A" (supplied) to the
ground wire that should be inserted into one of the spade terminals on the wall of the container (C).
2. Connect ground cable to cover Faston connector (B).
3. Secure the wires by fastening them in anchoring point (F) with the strip provided.

Wires with cross-section area of 0.5 mm² or larger must comply with IEC 60332-1-2; wires with
crosssection area smaller than 0.5 mm² must comply with IEC 60332-2-2.
4
POWER SUPPLY
C
F
BATTERY
RETE DI ALIMENTAZIONE
MAINS POWER
6,3 x 0,8 mm female
faston terminal
A
DS1067-112A