HEYLO DE20 Betriebsanleitung Seite 36

Electric heater DE20
CAUTION
Risk of burning due to hot surfaces
The device covers on the outlet side can reach
high temperatures during operation.
a) Wear protective gloves.
20.1 Cleaning the device
NOTICE
Suitable cleaning agents
You can obtain suitable cleaning agents for
cleaning your device from your dealer or directly
from DANTHERM.
The cleaning intervals for the device will depend
on the conditions of use. Therefore check and
clean the device regularly.
Cleaning the outside of the device
Cleaning can be performed with compressed air, a
vacuum cleaner (e.g. for cleaning dusty electrical
components) or by wiping with a damp cloth.
CAUTION! Never use a high-pressure cleaner.
CAUTION! Electrical components must never
come into contact with water or chemical clean-
ers.
Proceed as follows to clean and check the condi-
tion of the device:
a) Move the Operating mode rotary selector to
the 0 position and pull out the mains plug.
b) Wait until the temperature at the outlet nozzle
has dropped to ≤ 30°C.
Cleaning the inside of the device
a) Open the safety cover.
b) Clean the safety cover and the housing with a
damp, lint-free cloth and a mild detergent.
c) Clean the electrical components with com-
pressed air.
34 / 36
d) Wait until all the components that have been
wiped are dry.
e) Close the safety cover as intended at the fac-
tory.
 The device has now been cleaned.
20.2 Customer service by the
manufacturer
If the device states are unclear and you have any
questions about repair, the DANTHERM service
will be happy to help.
See also
 Contacting Dantherm GmbH
21 Repairs
The following section describes who may repair
the device and how it can be repaired.
NOTICE
Repairs may only be carried out by staff author-
ised by the manufacturer during the warranty pe-
riod of the device.
Repairs performed by the company
operating the device
After the statutory warranty has expired, repairs
may be carried out by the company operating the
device, provided appropriate expertise is shown.
DANTHERM will not assume any liability for these
repairs.
Contact the DANTHERM service department or
your dealer if you have any questions about re-
pairs.
See also
 Contacting Dantherm GmbH
[ 22]
[ 22]
EN