Quick Start - Tesla AI100 Benutzerhandbuch

3.2 Quick Start

1. Plug in the charging dock and place the remaining wire into the fitting at the
bottom of the charging dock.
Note: Failure to place the remaining wire into the fitting, may cause the robot to
become stuck while charging or cleaning.
2. Place the charging dock on a hard level surface and against
a wall as in the diagram below.
3. Charging dock position
• Place the charging dock against the wall and make sure it is in an open and unc-
luttered area leaving at least:
• 2 metres (6 feet) in front of the charging dock.
• 1 metre (3 feet) on both sides of the charging dock.
4. Install the side brushes.
Attached the side brushes to the bottom of robot by pressing into each slot until
hearing a click.
5. Activate the robot.
Place the robot onto the charging dock, make sure the metal charging contacts on
the charging dock match up with those underneath the robot.
If successful, you will hear a series of tones, once the Power button illuminates, the
robot is ready for use
9
EN