Wohler VIS 2000 Bedienungsanleitung Seite 12

Operation
2 Operation
Elements
Fig.1. Elements
Operation of the device
2.2.1 Conncetion to cable or rod
2.2.2 Switching the camera head
on and off with the monitor
unit
3 Guide conducts for the
inspection
12
1 Lens
2 Illumination
3 Connection to cable or ord
All camera-heads are connected via a
clutch socket with 8 poles to the cable or
the rod.
Plug the camera head and camera cable
or the rod together and then turn the
thread clockwise for closing the screw
connection tightly for a waterproof connec-
tion.
Nach Einschalten des Farbmonitors leuch-
ten die Lampen des Miniatur-
Kamerakopfes und nach einer Versions-
meldung erscheint das Bild auf dem Moni-
tor.
As all tubes and chimney sistems are dif-
ferent, the user has to decide about the
guide conducts in every single case. For
the selection of the correct guide conduct it
is important to consider that the guide
conduct has to facilitate the introduction
and the extraction of the camera head, as
well as an adequate guidance. The danger
of jamming or getting stuck in the tube has
to be avoided.
Inspection
Inspection of a tube
Ø 50 – 70 mm
Inspection of a tube
Ø 70 – 100 mm
Inspection without
bends will be possi-
ble.
An inspection will be
possible without