AEG SR 4366 CD/MP3 Bedienungsanleitung Seite 39

Playing back Music in MP3 Format
With this device it is possible to play back pieces of music in
MP3 format. The device also supports all standard CD types:
CD, CD-RW, CD-R.
This machine of is able to play MP3 CDs. Up to 200 tracks
can be compressed and stored on these CDs. Your machine
detects an MP3 CD automatically (the total number of tracks
and MP3s appears in the display). If you would like to play
one of these CDs, proceed as described under "Playing
CDs/MP3". Tracks can be programmed as described under
"Playing Back Programmed Tracks".
Please note:
There are a number of different recording and compression
methods, as well as quality differences between CDs and self-
recorded CDs.
Furthermore, the music industry does not adhere to fixed
standards (copy protection).
For these reasons it is possible that in rare cases there are
problems with the playback of CDs and MP3 CDs. This is not
a malfunction of the device.
Cassette operation
Playback of cassettes
1. Set the function selector switch (27) to position "TAPE
OFF".
2. Press the button (17), to open the cassette deck (15).
3. Slide a recorded audio tape into the deck with the tape
opening facing upwards and with the side to be listened
to facing the front (full reel to the right).
4. Close the cassette deck again.
5. Press the button (13) to restart the playback.
Description of the operating buttons
(13)
Starts the playback.
(17)
• Stops playback.
• In stop-mode to open the cassette deck.
/ (16/14)
Rewinding or fast forwarding of the tape.
CAUTION:
Always press the button (17) between switching over
the cassette and to stop the tape play function. By doing
so, you prevent damage to the cassette tape or on the
device.
(18)
Briefly pauses playback. Pressing the button again will con-
tinue playback.
Cleaning and Maintenance
• Always remove the mains plug before cleaning the
machine.
• Any marks on the surface can be wiped off with a slightly
damp cloth without any additives.
Troubleshooting
Symptoms Course
CD can not be CD is not inserted
played back. or inserted incor-
rectly.
Batteries too weak. Insert new batteries
CD jumps dur- Check the disc for
ing playback. fingerprints, dirt or
scratches.
Device cannot Device crashes and
be operated. "hangs".
NOTE: Automatic Standby switch
In order to comply with the "ErP 2 (Energy-related
Products)" Ecodesign Directive (2009/125/EC) that aims
at animproved energy efficiency and general environmen-
tal compatibility, the device will automatically switch to
standby after a certain amount of time without a signal. To
use the device again press the
Technical Data
Model: .................................................................. SR 4366 CD/MP3
Power supply: .......................................................AC 230 V~ 50 Hz
Battery operation: .........................................6 x 1.5 V Type D/R20
Power consumption:.................................................................15 W
Protection class: ................................................................................II
Net weight: ..............................................................approx. 1.78 kg
Radio section:
Frequency ranges: ...............................FM 87.5 ~ 108.0 MHz
.................................. AM 526 ~ 1606 kHz
The right to make technical and design modifications in
the course of continuous product development remains
reserved.
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance
with the latest safety regulations.
English
39
Solution
Ensure that the disc is
inserted with the label
facing upwards.
or operate the device
with the mains lead.
Check the disc for
fingerprints, dirt or
scratches.
Disconnect the power
supply for 5 sec. Then
switch the device on
again.
/ button (10).