Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connecting the Units
Note
¢ This unit is for vehictes with a 12-volt bat-
* When replacing fuses, be sure to use only
tery and negative grounding. Before
fuses of the rating prescribed on the fuse
installing it in a recreational vehicle, truck,
holder.
or bus, check the battery voltage.
* Since a unique BPTL circuit is employed,
¢ Check whether installation and wiring have
* Speaker connected to this unit must be
been completed correctly. Replace the
high-power types possessing minimum
removed car components, then connect the
rating of 30 W and impedance of 4 to 8
end of the cable to the negative © terminal
ohms. Connecting speakers with output
of the battery.
and/or impedance vatues other than those
* Refer to the owner's manual for details on
noted here can damage the speakers.
connecting the power amp, then make con-
* When a power amp is being linked with
nections correctly.
this system, be sure not to connect the blue
¢ Secure the wiring with cable clamps or
lead to the amp's power terminal. Likewise,
adhesive tape. To protect the wiring, wrap
when linking this system with the auto-
it in adhesive where it lies against metal
antenna, do not connect the blue lead to
parts.
the antenna's power terminal. Such con-
* Route and secure all wiring so it cannot
nections can make overcurrent and cause
touch any moving parts, such as the gear
malfunctions.
shift, handbrake and seat rails. Do not
* When the unit is mounted in a vehicle
route wiring in places that get hot, such as
whose ignition switch does not have the
near the heater outlet. If the insulation of
ACC (accessory) position as shown below,
the wiring melts or gets torn, there is a
be sure to connect the red tead of the unit
danger of the wiring short-circuiting to the
to the terminal controlled by the ignition
vehicle body.
switch ON/OFF position. If you do not, the
* Don't pass the orange lead through a hole
vehicle battery may go flat when you leave
into the engine compartment to connect to
your vehicle for several hours.
the battery. This will damage the lead insu-
lation and cause a very dangerous short.
* Do not shorten any leads. If you do, the
protection circuit may fail to work when it
should.
« Never feed power to other equipment by
cutting the insulation of the power supply
lead of the unit and tapping into the lead.
The current capacity of the lead will be
exceeded, causing overheating.
ACC position
No ACC Position
Werbung
