Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CHANGE
OF MAINS
Before you connect the machine to the mains,
make certain that the machine is coupled on the
correct mains voltage. The change of voltage is
performed according to pictures on page 3 or ac-
cording to circuit diagram.
CONTROL
DEVICES
KEMPAK 200: power source unit
Main
switch
Signal lamp
Selecting switch
Current
control
- memory
scale
- current
scale
Connection
for remote
control
Remote
control
devices
- C 100C, C 100D, C loop
Connection for welding
cable
OPERATION
MMA
WELDING
KEMPAK 200 AND COMBINATION
The current is adjusted with local control potentio-
meter (on the machine) or with potentiometer of
the remote control unit. The selecting switch for
local/remote control has to be in corresponding
position.
TIG
WELDING
TIG
200 DC
The remote control device is connected to the re-
mote
control
connector
of the KEMPAK
The selecting switch is in position 'TIG'.
The torch is connected to the shielding gas/current
connector
and the control
The supply connector for the shielding gas is on
the rear panel of the TIG unit.
12
VOLTAGE
(see picture on pag€; 2)
vo
local/remote
stepless
1-10
10 - 200A
am phenol-
connector
2 pc DIX connectors
WAYS (see scheme
s
KEMPAK 200 + TIG 200 DC
200.
connector.
Connection of primary cable to the mains supply
and changes to any internal primary voltage con-
nectors should only be carried out by a competent
electrician.
TIG 200 DC: TIG
unit
Selecting switch
Down-siope time
Postgas flow time
Selecting switch
Signai iamp
Connection for welding
torch
Weldin,::
Shielding gas connector
page 2)
The current value is adjusted according
trode diameter and welding situation.
In combination the seiecting switch of the TIG unit
is in position for MMA weiding.
Because of short circuit danger the cable for MMA
welding
may not be connected
during TEGwelding.
KEMPAK 200 power source can be used for TIG
welding when striking ignition and torch including
connection ior shielding gas are applied,
TIG. MMA
0 - 15 s, dependent
on
current
5-80
s
continuous/ho!d
ampherol-
and
gas/current
connector
cone
connector
R8/8
the elec-
to the machine
Werbung
Inhaltsverzeichnis
