Werbung
Verfügbare Sprachen
Verfügbare Sprachen
T O p p a n e l
3
4
GND LIFT SWITCH
3
Switches the XLR (5) PIN 1 from direct contact with ground in the event that hum occurs.
THRU / HIGH PASS FILTER SWITCH
4
Switches the THRU/HPF output jack between a full-bandwidth thru, or a high-pass out with a corner frequency of 120
Hertz for connection to the amplifier of a mid-high speaker.
PRIMARY INPUT
5
This line-level balanced XLR input is of the medium impedance (10k) balanced type.
THRU /HPF OUTPUT
6
This line-level balanced XLR output either is a full bandwidth thru, or a high-pass crossover output as determined by
the THRU/HPF switch (4) described above.
SPEAKER LEVEL IN
7
This 1/4" T-S speaker-level input is of the medium impedance (10k) unbalanced type. It is internally padded to accept
speaker level signals from an amplifier that also might be powering the mid-high frequency speakers.
Note: DO NOT connect a bridged amplifier output to this jack, or a single power amplifier channel that has the
polarity reversed. The jack sleeve is grounded.
LEVEL CONTROL
8
Controls the gain (level) of the system. It is used to directly adjust the amount of bass when associated with a
separate mid-high speaker system
POWER/CLIP LED
9
Illuminates GREEN when the electronics receive power (when the Power switch (3) is On). Illuminates RED when
amplifier clipping is occurring or the unit has tripped the thermal protection system.
5
6
7
8
9
Werbung
