Klarstein ICEFESTIVAL BULLET Bedienungsanleitung Seite 16

EN
16
DEVICE OVERVIEW
1 Rear cover
2 Cup holder
3 Middle frame
4 Rear housing
5 Fan
Installation
• When transporting the device, make sure that the tilt angle of the housing is
not more than 45°. Otherwise the compressor and the sealing system can be
damaged.
• Remove all packing materials and ensure that the device is in good condition
and that the device, plug, or power cord are not damaged.
• Place the device horizontally on a level surface. Keep a minimum distance
of 150 mm to each side of the device to ensure adequate ventilation. Do not
install the device near stoves, heaters or other heat sources.
• Make sure that the voltage used corresponds to the voltage specified on the
type plate of the device.
• Use normal drinking water for the device. The use of distilled water is
prohibited.
6 Front cover
7 Control panel
8 Housing front
9 Evaporator
10 Water bowl
11 Access board
12 Ice level sensor
13 Ice bucket