Onkyo TX-902 Betriebsanleitung Seite 4

Use of Batteries. . Gidea tighs d e c t a h , , Wd aad vetie ee
© The remote control transmitter is powered by two batteries.
Before using this unit for the first time, insert the two batteries
(included) as shown in the diagram.
@ Average battery life is about one year. This period may be shorter
depending on the frequency of use and environment. (temper-
-cature.and: humidity). in:which the remote control transmitter. is
used.
@ {f the remote control transmitter does not operate even though
~ front panel controls function normally, the batteries should be
replaced. Use only batteries listed in the following chart.
| type | Voltage | Size |
: BAL os
Manga- —
"nese
. Do not leave an expired battery in the ca
or damage the battery case. 7
2. When inserting the batteries, be sure:'the.(+) and (—) ends
are properly aligned. : i
3. Do not use nickel-cadmium (rechargeable) batteries.
4. Do not use one specified: (manganese) battery and:one al-
kaline battery at the same time. : :
5. Replace both batteries at once; do not use one old and one
new battery together. Suey Bh
@ Push the battery cover on the rear of the transmitter in the di-
rection of the arrow and lift it up.
Load the two batteries that came. with the transmitter or two
batteries listed in the table. Load them with the + and — ends
facing as shown in the diagram.
® Put the battery cover back in place.
se as it may leak