Troubleshooting; Care & Cleaning - Sage the Boss To Go BPB550 Kurzanleitung

Troubleshooting

Motor doesn't start or • Check that the power plug is properly inserted into the power outlet.
blade doesn't rotate
• Overload Protection System may have operated (see below).
Blender stopped
• This extractor has overload protection to prevent damage to the motor,
suddenly while in use
which may have operated. Unplug, remove the cup and allow the motor
to cool down for 30 minutes. Once cooled, you will be able to use
as usual again.
• We recommend blending in smaller batches, or cutting ingredients
into smaller pieces. See Overload Protection System section for
detailed information.
Food is lumpy or
• This can happen when too much food is being blended at one time.
unevenly blended
Try a smaller amount, and work in batches if necessary.
• The ingredients may be too large. Try cutting into smaller pieces.
For best results, ingredients should be in pieces no larger than 2cm.
Food sticks to • The mixture may be too thick. Try adding more liquid and/or pulsing
blade and cup the blender.
8
All manuals and user guides at all-guides.com
Unplug the power cord from the power outlet after
use for safety reasons.
Tumbler cups and lids
To keep your cups and lids clean, avoid allowing
food residue to dry on them. Follow these steps as
soon as possible after use:
• Rinse most of the residue off the blades,
cup and lid.
• Hand wash in warm, soapy water using a mild
liquid detergent and non-abrasive sponge.
Motor base
To clean the motor base, wipe with a soft, damp
cloth then dry thoroughly. Wipe any excess food
particles from the power cord.
Cleaning agents
Do not use abrasive scouring pads or cleansers
on either the motor base or the cups, as they may
scratch the surface. Use only warm soap water
with a soft cloth.
Pressurisation
The cups may be rinsed by adding cold water,
attaching blades, and either blending or shaking
by hand for 10 seconds.
IMPORTANT: There is a risk of pressurisation
from hot water and/or detergent.
When rinsing by attaching blades and blending/
shaking, never add hot or even warm water,
as the steam produced can create dangerous
pressurisation.
Do not add detergent, as the foam produced
will expand and may cause pressurisation.
Dishwasher
The cups, lids and blade assembly may be
washed in the dishwasher on the top shelf only.
Care & Cleaning
Citrus
Exposure to citrus oil may affect the clarity
and longevity of the Tritan cups. After washing
in detergent, rinse with plain water thoroughly,
and allow to dry immediately.
Do not soak if citrus has been blended.
Do not attach blades when washing with detergent.
Storage
Store upright with the cups and blades assembled
and resting on the motor base, or beside it.
Do not store with the cup turned to the ON position,
as this means the motor is engaged and will turn
on immediately when plugged in or switched on
at the wall.
EN
9