Battery Mounting - Carson Tyrann 380 Pro Betriebsanleitung

4. Tail rotor sensitivity setup (RUDD) –
Expert mode
Hold down the "ENT" function key for 1 second, to enter the setting
status. Press the "DN" key repeatedly, till the 5 points will start to flash
(see picture). Press tail rotor trim (RUDD) to set the sensitivity. Then
press the EXT key for 2 seconds, to confirm and exit.
GB
5. Nick sensitivity setup (ELEV) – Expert mode
Hold down the "ENT" function key for 1 second, to enter the setting
status. Press the "DN" key repeatedly, till the 5 points will start to flash
(see picture). Press nick trim (ELEV) to set the sensitivity. Then press
the EXT key for 2 seconds, to confirm and exit.
6. Roll Nick sensitivity setup (AILE) –
Expert mode
Hold down the "ENT" function key for 1 second, to enter the setting
status. Press the "DN" key repeatedly, till the 5 points will start to flash
(see picture). Press roll trim (AILE) to set the sensitivity. Then press the
EXT key for 2 seconds, to confirm and exit.
g. Battery Mounting
Caution:
• Do not mix old and new batteries/rechargeable batteries.
• Do not mix different types of batteries.
• Do not charge non-rechargeable batteries.
1
Open the battery cover.
32 CARSON Mini Tyrann 380 Pro • 50 050 7052
2
Take out the battery box.
3
According to the correct polarities, install
8 x AAA batteries.