Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.5
PROWEATHERLIVE DASHBOARD APPS
Android and iOS ProWeatherLive apps are available in addition to proweatherlive.net. Search
"proweatherlive" in iOS App Store or Google Play.
8.
OTHER FUNCTIONS
8.1
BACKLIGHT
The console backlight brightness can be adjust by using the [ BACKLIGHT ] slide switch to select the
appropriate brightness:
- Slide to the [ HI ] position for the brighter backlight.
- Slide to the [ LO ] position for the dimmer backlight.
- Slide to the [ AUTO ] position for the auto adjust back light that according to environment light level
8.2
MAINTENANCE
8.2.1 BATTERY REPLACEMENT
When low battery indicator "
current sensor battery power is low respectively. Please replace with new batteries.
8.2.2 CHANGING BATTERIES AND MANUAL PAIRING OF SENSOR
Whenever you changed the batteries of the wireless sensor, re-synchronization must be done manually.
1. Change all the batteries to new ones in the sensor.
2. Press [ SENSOR / WI-FI ] key on the console to enter sensor Synchronization mode.
3. Console will re-register the sensor after its batteries are changed (about 1 minute).
8.2.3 REMOVE WIRELESS SENSOR(S) CONNECTION
In order to remove the sensor(s) connection, please follow below steps:
1. Remove sensor batteries.
2. Press [ SENSOR / WI-FI ] key once to clear the sensor history.
8.3
FIRMWARE UPDATE
The console supports OTA firmware update capability. Its firmware may be updated over the air anytime
(whenever necessary) through WSLink app.
1. The latest firmware will be download to your smart phone automatically, just connect your
console to WSLink to check for update (Section 6.7).
2. Follow the app step to transfer the OTA file from smart phone to console
3. Once file transferred, the console will start to update, the
update time is around 5 ~ 10 minutes. While updating, the
progress will be displayed (i.e. 100 is completion).
4. The console will restart once the update is completed.
IMPORTANT NOTE:
- Please keep connecting the power during the firmware update process.
- Please make sure your console WI-FI connection is stable.
- When the update process start, do not operate the console until the update is finished.
- Settings and data maybe lost during update.
- During firmware update the console will stop upload data to the cloud server. It will reconnect to your WI-
FI router and upload the data again once the firmware update succeed. If the console cannot connect to
your router, please enter the SETUP page to setup again.
- Firmware update process have potential risk, which cannot guarantee 100% success. If the update fail,
please redo the above step to update again.
- If firmware update fail, press and hold the [ SET ] and [ UNIT ] key at the same time with 10 seconds to
back to original version, then redo the update procedure again.
" or "
" appear on top of the sensors' reading, it indicates that the
44
Werbung
Kapitel
Inhaltsverzeichnis
