GreenWorks G40LT Montageanleitung Seite 9

EN
4.5 ADJUST THE LENGTH OF THE
CUTTING LINE
Figure 11.
The machine has an auto-feed head. If the cutting line
does not automatically advance, it can be tangled or
empty.
1. Start the machine and keep 3s. Release the trigger
until the machine totally stops.
2. Repeat the above step until you can hear the line-
cutting noise.
The line will extend approximately 1 cm with each stop
and start of the switch trigger until the line reaches
the cut-off blade and the cut-off blade cuts the excess
length.
Do not pull or release the trigger too fast.
It will damage the machine if you hit the head to try to
advance the line.
4.6 ADJUST THE LENGTH OF THE
CUTTING LINE MANUALLY
Figure 14.
1. Stop the machine.
2. Push the spool retainer button and pull on cutting
line to manually advance the cutting line.
3. After you extend new cutter line, always return the
machine to its normal position before you start it
again.
4.7 LINE CUT-OFF BLADE
Figure 1.
This trimmer is equipped with a line cut-off blade
on the guard. The line cut off blade continuously
trims the line to ensure a consistent and efficient cut
diameter. Advance line whenever you hear the engine
running faster than normal, or when trimming efficiency
diminishes. This will maintain best performance and
keep the line long enough to advance properly.
NOTE
NOTE
NOTE
NOTE
English
5 MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight.
Check regularly that the handles are firmly mounted.
Use only the replacement parts and accessories of the
initial manufacturer.
5.1 GENERAL INFORMATION
Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in a cool and dry place.
• Use correct clothing, protective gloves and safety
glasses.
5.2 CLEAN THE MACHINE
• Clean the machine after each use with a moist cloth
dipped in neutral detergent.
• Do not use aggressive detergents or solvents like
"glass cleaner" to clean the plastic parts or handles.
• Keep the trimmer head free from grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage of the motor.
• Do not spray water onto the motor and electrical
components.
5.3 REPLACE THE SPOOL
Figure 15 - 16, 21 - 22.
1. Push the tabs on the sides of the trimmer head at
the same time.
2. Pull and remove the spool cover.
3. Remove the remaining spool.
4. Put the spool in the spool housing.
6
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT