GreenWorks GD48LM41II Bedienungsanleitung Seite 9

EN
4.5 OPERATION TIPS
• Do not try to override the operation of the start
button or bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning
parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick
grass.
• Clean the bottom of the mower deck after each
use. Remove grass clippings, leaves, dirt, and other
debris.
5 MAINTENANCE
Remove the battery pack(s) from the machine before
maintenance.
Keep the motor and battery pack(s) free from grass,
leaves or too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Recommended tightening torque (blade): 33-37 Nm.
5.1 GENERAL MAINTENANCE
• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use
water.
5.2 REPLACE THE BLADE
Figure 10-11
WARNING
WARNING
CAUTION
CAUTION
CAUTION
NOTE
English
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
1. Stop the machine.
2. Make sure that the blades fully stop.
3. Remove the battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw and spacer with a 5/8
Inch (15mm) wrench or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the arrows
engage the holes in the blade.
9. Put in the mounting screw and spacer and tighten
them.
5.3 STORE THE MACHINE
• Clean the machine before storage.
• Make sure the motor is not hot when you put the
machine into storage.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
You may lower the handle(s) before you put the
machine into the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
6
WARNING
WARNING