Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6
TROUBLESHOOTING
Problem
Possible cause
The handle is
The bolts are not
not in position.
engaged correct-
ly.
The product
The battery ca-
does not start.
pacity is low.
The start handle
is defective.
The product cuts
The lawn is
grass unevenly.
rough.
The blade height
is not set cor-
rectly.
The product
Wet grass clip-
does not mulch
pings attach to
correctly.
the deck.
The mulch plug
is missing.
The product is
The grass is too
hard to push.
tall, or the blade
height is too low.
The grass catch-
er and the blade
drags in thick
grass.
There is a high
The blade is un-
vibration in the-
balanced and
product.
worn.
The motor shaft
is bent.
The product
The blade height
stops during
is too low.
mowing.
The battery pack
is out of power.
English
Problem
Solution
Adjust the height
of the handle
and make sure
that the bolts
and nuts are
aligned correctly.
Charge the bat-
* If you cannot find the solution to these problems, go to
tery pack.
the service center.
Replace the start
7
handle.
Examine the
Voltage
mowing area.
No load speed
Move the wheels
to a higher posi-
Cutting width
tion.
Cutting height
Wait until the
Grass catcher capacity
grass dries be-
fore mowing.
Measured sound pressure
level
Install the mulch
plug.
Guaranteed sound power
level
Increase the
blade height.
Vibration
Battery model
Empty the grass
clippings from
the grass catch-
Charger model
er.
Replace the
IPX
blade.
8
1. Stop the mo-
tor.
(The full warranty terms and conditions can be found on
2. Remove the
Greenworks website https://www.greenworkstools.eu)
battery pack.
The Greenworks warranty is 3 years on the product,
3. Disconnect
and 2 years on batteries (consumer/private usage)
the power
from the date of purchase. This warranty covers
source.
manufacturing faults. A faulty product under warranty
4. Inspect for
might be either repaired or replaced. A unit that has
damage.
been misused or used in other ways than described
5. Repair the
in the owner's manual might be ineligible for warranty
product be-
coverage. Normal wear and tear are not covered under
fore you start
warranty. The original manufacturer warranty is not
it again.
affected by any additional warranty offered by a dealer
or retailer.
Increase the
blade height.
A faulty product must be returned to the point of
purchase in order to claim for warranty, together with
Charge the bat-
the proof of purchase (receipt).
tery pack.
7
Possible cause
The grass clip-
pings attach to
the deck or the
blade.
Operation tem-
perature of the
product is too
high.
TECHNICAL DATA
48 V
3500 / min
410 mm
25 - 80 mm
50 L
L
= 80.1 dB(A) , K = 3
PA
dB(A)
L
WA.d
< 2.5 m/s
G4824B2, G4824B4,
G4824B5, G4824B4+ and
other BAM series
G4824C4, G4824C and
other CAM series
IPX4
WARRANTY
EN
Solution
Remove the bat-
tery pack and
check the deck.
Cool the product.
= 96 dB(A)
2
2
, K = 1.5 m/s
Werbung
