Herunterladen Diese Seite drucken

AMI 4E Montage- Und Bedienungsanleitung Seite 31

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

9 Stove operation
Lighting
Fully open the air vent below the
door. Place two logs 27-30 cm on
the firebed . In order to avoid sooting on
the glass, it is important that
the log is not placed adjacent to
the glass, subsequently place two
firelighters on these logs. Stack
dry, finely split wood on the bottom logs in
the centre of the firebox and
build up like a log house.
Under supervision, leave the door slightly open about 1-2 cm after lighting the fire (5-10
minutes). This ensures that the fire has sufficient combustion air after lighting. Once the
fire is burning and the glass panel is sufficiently warm, the door can be closed.
Refulling
When the fire has burned to embers (no flames), carefully open the door so as not to
disturb the ash, spread the embers evenly. Place 1-3 pieces of wood,which should not be
stacked higher than the horizontal holes on the back burn plate,in the centre of the
firebox (parallel with the front side) and subsequently close the door.
Wait about 2-5 minutes until the wood is properly alight and move the air vent to the
center position. The amount the air vent could also be moved to the largest depends on
the flue draught. A "strong" flame should always be visible in the stove.
Ash
Ash should always be present in the firebox. A fire burns best on a bed of ash. Embers
collect more quickly through the ash and glow longer. We recommend removing the ash at
the earliest after using the stove 10 times. The ash can be disposed of in a dustbin.
10. Maintenance
Cleaning the glass
The stove is equipped with an air wash for the glass. Air is sucked in through the air vent
on the top of the stove and down along the inside of the glass. However, some soot will
always stick to the glass, Most of the soot layer will normally be burned off when the air
vent is opened all the way and a fire is burning briskly in the firebox.
Good advice! For normal cleaning, moisten a paper towel with warm water and add some
ash from the burn chamber. Rub it over the glass and then clean the glass with clean
water. Dry well.
GB31

Werbung

loading

Diese Anleitung auch für:

4e-ls