KKT KOLBE EASY Benutzerhandbuch Seite 60

Mounting the hood
• Remove the shaft again.
Place the top edge of each of the shaft
brackets against the corresponding
markings, mark the screw holes on
the wall and drill 2 holes at each of
the marked points according to the
diameter of the dowels.
• Fasten the two shaft brackets to the
wall with 2 dowels and screws
(4.2 × 30 mm) each.
• For exhaust air operation of the hood,
attach the exhaust air hose to the air
outlet of the hood body and connect it
to the exhaust air pipe.
60
• Now hang the two shaft elements onto
the wall brackets from top to bottom
and fix the upper element with the
two short screws supplied
(3.5 × 10 mm).
• Finally, fix the outer shaft part to the
canopy body with the 2 remaining
short screws.
• Make sure that the metal grease
filter is reinserted before using the
appliance.